| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A vulnerability was identified in Tenda G0 up to 20260625. This issue affects the function formSetPortMirror of the file /goform/module of the component httpd Web Management Interface. Such manipulation of the argument portMirrorMirroredPorts leads to stack-based buffer overflow. The attack can be executed remotely. The exploit is publicly available and might be used. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_uart: clear HCI_UART_SENDING when write_work is canceled
HCI_UART_SENDING bit in tx_state means write_work is pending and blocks
queueing it again. Currently this bit is not cleared when canceling the
work in hci_uart_close(), which blocks future writes when device is
reopened later if write_work was pending.
Fix by clearing HCI_UART_SENDING when canceling the work.
Also make clearing of tx_skb safe by using disable_work_sync +
enable_work instead of just cancel_work_sync. hci_uart_flush() purges
the proto tx queue so we can cancel the pending write_work there,
instead of doing it just in hci_uart_close(). Re-enable and possibly
requeue the work after queue flush. |
| In the Linux kernel, the following vulnerability has been resolved:
firewire: net: Fix fragmented datagram reassembly
fwnet_frag_new() keeps a sorted list of received fragments for a partial
datagram. When a new fragment is adjacent to an existing fragment, the
code checks whether the new fragment also closes the gap to the next or
previous list entry.
Those neighbor lookups currently assume that the current fragment always
has a real next or previous fragment. At a list edge, the next or
previous entry is the list head, not a struct fwnet_fragment_info.
The gap checks also compare against the old edge of the current fragment
instead of the edge after adding the new fragment. As a result, a
fragment that bridges two existing ranges may leave two adjacent ranges
unmerged, so fwnet_pd_is_complete() can miss a complete datagram.
Check for the list head before looking up the neighboring fragment, and
compare the neighbor against the new fragment's far edge when deciding
whether to merge all three ranges.
This issue was found by a static analysis checker and confirmed by
manual source review. |
| A vulnerability was determined in Tenda AC1206 15.03.06.23_multi_TD01. This vulnerability affects the function set_wl_guest_iplist of the file /goform/WifiGuestSet of the component httpd web management interface. This manipulation of the argument shareSpeed causes stack-based buffer overflow. Remote exploitation of the attack is possible. The exploit has been publicly disclosed and may be utilized. |
| A vulnerability was found in Tenda AC1206 15.03.06.23_multi_TD01. This affects the function set_device_name of the file /goform/SetOnlineDevName of the component httpd web management interface. The manipulation of the argument devName results in stack-based buffer overflow. The attack may be launched remotely. The exploit has been made public and could be used. |
| A vulnerability was determined in SourceCodester Air Cargo Management System 1.0. Impacted is an unknown function of the file /classes/Master.php?f=save_cargo_type. Executing a manipulation of the argument ID can lead to sql injection. The attack can be executed remotely. The exploit has been publicly disclosed and may be utilized. |
| Improper isolation of shared resources within the CPU operation cache on Zen 2-based products could allow an attacker to corrupt instructions executed at a different privilege level, potentially resulting in privilege escalation. |
| A malicious SSH peer could send unsolicited global request responses to fill an internal buffer, blocking the connection's read loop. The blocked goroutine could not be released by calling Close(), resulting in a resource leak per connection. Unsolicited global responses are now discarded. |
| In the Linux kernel, the following vulnerability has been resolved:
smb: client: fix double-free in SMB2_close() replay
A response-bearing attempt can return a replayable error and free its
response buffer. If SMB2_close_init() fails before the next send, cleanup
retains the previous buffer type and frees that response again.
Reset response bookkeeping before each attempt to prevent the stale free. |
| In the Linux kernel, the following vulnerability has been resolved:
ksmbd: validate ACE size against SID sub-authorities
set_ntacl_dacl() validates sid.num_subauth before copying an ACE, but
does not verify that the declared ACE size contains all sub-authorities
described by that field. An undersized ACE can therefore be copied
and later make the POSIX ACL deduplication walk inspect data beyond
the copied ACE boundary.
The existing initial bound check is also too small. It only ensures
that the ACE size field is accessible before set_ntacl_dacl() reads
sid.num_subauth farther into the input buffer.
Require enough input for the fixed SID header before accessing
num_subauth, reject ACEs smaller than that header, and skip ACEs
whose declared size cannot contain the complete SID. This makes the
validation consistent with the other ACE walk paths. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amdkfd: fix 32-bit overflow in CWSR total size calculation
total_cwsr_size was computed in 32-bit before being used as a BO/SVM
allocation size.
With large ctx_save_restore_area_size and debug_memory_size
multiplied by the XCC count, the product can wrap,
yielding an undersized CWSR save area that firmware later overruns.
Promote total_cwsr_size to u64 and use check_add_overflow()/
check_mul_overflow() in both kfd_queue_acquire_buffers() and
kfd_queue_release_buffers().
(cherry picked from commit 319f7e13423ae3f486b9aea82f9ad2d6af0ee608) |
| Vault Secrets Operator 1.3.0 up to 1.4.1 is vulnerable to an arbitrary file read and credential exfiltration issue in the AppRole authentication configuration that may allow a tenant with limited Kubernetes RBAC permissions to read files from the operator pod's filesystem and transmit their contents to a tenant-controlled endpoint, potentially leading to privilege escalation within the cluster. This vulnerability (CVE-2026-8715) is fixed in Vault Secrets Operator 1.5.0. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu/vce: fix integer overflow in image size
Fix a security vulnerability where malicious VCE command streams
with oversized dimensions (e.g. 65536×65536) cause 32-bit integer
overflow, wrapping the calculated buffer size to 0. This bypasses
validation and allows GPU firmware to perform out-of-bound memory
access.
The fix uses 64-bit arithmetic to detect overflow and rejects
invalid dimensions before they reach the hardware.
V2: remove redundant check
V3: modify max height value
V4: remove size64
(cherry picked from commit cbe408dba581755ad1279a487ec786d8927d778d) |
| In the Linux kernel, the following vulnerability has been resolved:
gve: fix Rx queue stall on alloc failure
When the system is under extreme memory pressure, page allocations can
fail during the Rx buffer refill loop. If the number of buffers posted
to hardware falls below a critical low threshold and the refill loop
exits due to allocation failures, the queue can stall:
1. The device drops incoming packets because there are no descriptors.
2. Since no packets are processed, no Rx completions are generated.
3. Because no completions occur, NAPI is never scheduled, preventing
the refill loop from running again even after memory is freed.
This results in a permanent queue stall.
Resolve this by introducing a starvation recovery timer for each Rx queue.
If the number of buffers posted to hardware falls below a critical low
threshold, start a timer to periodically reschedule NAPI. Once NAPI runs
and successfully refills the queue above the threshold, the timer is
not rescheduled.
The threshold is set to 32 because a single maximum-sized Receive Segment
Coalescing (RSC) packet can consume up to 19 descriptors in the Rx path.
Lower thresholds (such as 8 or 16) would be insufficient to process a
complete maximum-sized RSC packet, risking packet drops or unexpected
hardware behavior under memory pressure. Setting the threshold to 32
guarantees a safe margin to handle at least one full RSC packet. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: ath6kl: fix OOB access from firmware ADDBA window size
aggr_recv_addba_req_evt() logs a debug message when the firmware-supplied
win_sz is outside [AGGR_WIN_SZ_MIN, AGGR_WIN_SZ_MAX] but does not
return. The out-of-range win_sz is then used in TID_WINDOW_SZ() to
compute a kzalloc size and stored in rxtid->hold_q_sz, leading to
zero-size or overflowed allocations and subsequent out-of-bounds access.
Clean up any previously active aggregation session for the TID first,
then return early when win_sz is out of the valid range, instead of
proceeding with a broken allocation size. |
| In the Linux kernel, the following vulnerability has been resolved:
media: pwc: Return queued buffers on start_streaming() failure
The vb2 framework hands buffers to the driver via buf_queue() before
calling start_streaming(). If start_streaming() returns an error
without first returning those buffers via vb2_buffer_done(),
vb2_start_streaming() fires WARN_ON(owned_by_drv_count) and the queued
buffers leak.
pwc's start_streaming() had two early returns that hit this trap:
-ENODEV when the USB device was already disconnected, and -ERESTARTSYS
when mutex_lock_interruptible() was interrupted by a signal. Call the
existing pwc_cleanup_queued_bufs() helper with VB2_BUF_STATE_QUEUED
before returning (matching the state already used by the
pwc_isoc_init() error path in the same function).
This mirrors the uvcvideo fix in commit 4cf3b6fd54eb ("media: uvcvideo:
Return queued buffers on start_streaming() failure"). |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: tas2781: bound firmware description string parsing
The TAS2781 firmware parser reads several variable-length description
strings with strlen() before checking that the string terminator is
present inside the firmware blob. A malformed firmware image without a
NUL terminator can therefore make the parser walk past the end of the
firmware buffer before the later size checks run.
Add a small bounded string-length helper and use it for all description
fields that are parsed from the firmware buffer. Keep the existing size
checks for the fixed bytes that follow each string. |
| In the Linux kernel, the following vulnerability has been resolved:
bpf: Fix UAF in sock clone early bailouts
Similar to recent commit 9b51a6155d14 ("bpf,fork: wipe ->bpf_storage
before bailouts that access it"), sk_clone() performs an initial
shallow copy of the socket field ->sk_bpf_storage via sock_copy()
for the cloned socket newsk.
If sk_clone() bails out early (e.g. if sk_filter_charge() fails) prior
to calling bpf_sk_storage_clone(), newsk->sk_bpf_storage still points
to the parent socket's BPF local storage. When newsk is subsequently
freed via sk_free(), the deallocation path (__sk_destruct() ->
bpf_sk_storage_free()) destroys the parent socket's BPF local storage,
leading to a use-after-free (UAF) on the parent socket.
Fix this by resetting newsk->sk_bpf_storage to NULL immediately after
sock_copy() in sk_clone(), and remove the now redundant initialization
from bpf_sk_storage_clone(). |
| A vulnerability was found in francoisjacquet RosarioSIS up to 12.8. This issue affects some unknown processing of the file Modules.php. Performing a manipulation results in cross-site request forgery. Remote exploitation of the attack is possible. Upgrading to version 12.9 is capable of addressing this issue. The patch is named 801a71272c82cf4bf695fdc5ed42a9b7511d124d. It is recommended to upgrade the affected component. |
| The W3 Total Cache plugin for WordPress is vulnerable to Stored Cross-Site Scripting via Comment Author Name in all versions up to, and including, 2.10.3 due to insufficient input sanitization and output escaping. This makes it possible for unauthenticated attackers to inject arbitrary web scripts in pages that will execute whenever a user accesses an injected page. This vulnerability is only exploitable when the Lazy Load Images feature of W3 Total Cache is enabled, as the unsafe re-emission occurs exclusively within the LazyLoad mutator's img tag rewriting step. |
