| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A flaw was found in Keycloak. This vulnerability allows an authenticated remote attacker to cause a denial of service by terminating active sessions of arbitrary users. When processing Security Assertion Markup Language (SAML) documents that lack a root signature, Keycloak accepts the request as long as any assertion within the document is signed, without verifying its context or placement. An attacker holding a validly signed assertion can embed it into an unsigned logout request for another user, causing Keycloak to accept the forged request and terminate the victim's session. |
| In the Linux kernel, the following vulnerability has been resolved:
can: dev: can_dropped_invalid_skb: drop CAN XL frames on non-CAN XL devices
Sending a PF_PACKET bypasses the CAN framework logic and can directly
reach a CAN driver's xmit() function. The PF_PACKET framework only
checks that skb->len does not exceed the net_device MTU.
For a CAN device that is not CAN XL capable, anything above CANFD_MTU
(72 bytes) is therefore dropped before it reaches the driver. However,
CAN XL frames are variable length. can_is_canxl_skb() accepts lengths in
the range CANXL_HDR_SIZE + CANXL_MIN_DLEN up to CANXL_MTU, i.e. 13 to
2060 bytes.
As a result, an ETH_P_CANXL skb with a length between 13 and 72 bytes
can pass both the MTU and the can_dropped_invalid_skb() checks.
A driver that does not support CAN XL will interpret canxl_frame->flags
as a length because of the overlap with can_frame->len. And because
CANXL_XLF is set, the resulting length is between 128 and 255. For
drivers that do not check can_frame->len before copying can_frame->data,
as most drivers do, this results in a buffer overflow of up to 247
bytes.
Drop ETH_P_CANXL skbs if the device does not have the CAN_CAP_XL
capability. Keep can_is_canxl_skb() for the validation of CAN XL skbs. |
| In the Linux kernel, the following vulnerability has been resolved:
mm/vma: write lock source VMA before duplicating it in __split_vma()
__split_vma() duplicates the source VMA before taking its VMA write lock,
and until the VMA is write-locked, a concurrent thread might set
VMA_MAYBE_GUARD_BIT, resulting in the duplication missing the flag.
If this happens, then fork may fail to duplicate guard markers and, if a
file-backed mapping, THP collapse may also discard the markers.
Resolve this by taking the VMA write lock before vm_area_dup() and, since
all callers of vm_area_dup() now hold the VMA write lock, assert that this
is the case there, and add a comment to explain why it's needed.
[ljs@kernel.org: add VMA write assert in vm_area_dup(), commit message touchup] |
| In the Linux kernel, the following vulnerability has been resolved:
mm/page-writeback: avoid 32-bit overflow in dirty threshold shares
The ratios used by __wb_calc_thresh() are scaled to parts per million, but
the threshold and ratio operands are unsigned long. On 32-bit kernels,
their multiplication can wrap before the result is assigned to u64.
For example, with a threshold of 25600 pages and the default maximum ratio
of 1000000, wb_max_thresh becomes 4125 pages instead of 25600. The shared
threshold and minimum share calculations can overflow in the same way,
producing incorrect per-writeback dirty limits.
Use a u64 threshold for the three ratio multiplications and div_u64() to
retain the existing division order and rounding. |
| In the Linux kernel, the following vulnerability has been resolved:
mm: memory: fix truncation removing mapped folios
Ayush reported an issue that shmem/tmpfs folios are still mapped when
truncating them on production:
"
BUG: Bad page cache in process ... pfn:...
page dumped because: still mapped when deleted
"
I reproduced the issue with Ayush's reproducer [1] with the latest
mm-unstable branch, and I got the following crash info. From the dump
message, we can see that truncate_inode_folio() is really trying to remove
mapped folios, which is incorrect.
"
[ 189.171977] page: refcount:3 mapcount:1 mapping:00000000fe168ee1
index:0x3880 pfn:0x191647
[ 189.171995] memcg:ffff0000cc073d40
[ 189.171997] aops:shmem_aops ino:3c01 dentry name(?):"memfd:runsc-memory"
[ 189.172006] flags: 0x17fffef0002022d(locked|referenced|uptodate|lru|
workingset|swapbacked|node=0|zone=2|lastcpupid=0x3ffff)
.......
[ 189.172017] page dumped because: VM_BUG_ON_FOLIO(folio_mapped(folio))
[ 189.172026] ------------[ cut here ]------------
[ 189.172027] kernel BUG at mm/filemap.c:155!
[ 189.172057] Internal error: Oops - BUG: 00000000f2000800 [#1] SMP
.......
[ 189.177721] CPU: 3 UID: 0 PID: 5521 Comm: repro Kdump: loaded Tainted:
7.3.0-rc4+ #277 PREEMPT(lazy)
.......
[ 189.183986] Call trace:
[ 189.184124] filemap_unaccount_folio+0xf0/0x1e8 (P)
[ 189.184391] __filemap_remove_folio+0x34/0x160
[ 189.184633] filemap_remove_folio+0x4c/0xb0
[ 189.184859] truncate_inode_folio+0x34/0x58
[ 189.185087] shmem_undo_range+0x220/0x658
[ 189.185308] shmem_fallocate+0x2f0/0x470
[ 189.185527] vfs_fallocate+0x128/0x328
......
[ 189.187078] el0t_64_sync+0x184/0x188
"
After analysis, I believe the race exists between truncation and
MADV_DONTNEED, and shmem's ->map_pages() merely makes the issue easier to
reproduce. Since MADV_DONTNEED synchronously releases the pagetable page
before calling tlb_flush_rmaps(), this could cause another thread's
truncation to skip zap_pte_range() (due to pmd is none) but still observe
the folio's mapcount as non-zero. A possible race scenario is as follows:
CPU 0 CPU 1
shmem_fallocate madvise_dontneed_single_vma
unmap_mapping_range .......
......
(filemap_map_pages() remap folios)
zap_pte_range
truncate_inode_folio zap_empty_pte_table(pmd clear)
unmap_mapping_folio
......
zap_pmd_range (saw pmd none, skip)
filemap_remove_folio
BUG_ON(folio_mapped)
tlb_flush_rmaps(remove rmaps)
To fix this issue, we should move the pmd clear operation (via
zap_empty_pte_table()) to after tlb_flush_rmaps() and use
sync_with_folio_pmd_zap() to sync with concurrent zapping, so that when we
find a pmd_none() while unmapping a folio without holding the PTL, the
folio's mappings are guaranteed to have been removed via
tlb_flush_rmaps().
Meanwhile move the second pmd_none() check to where it belongs: if
splitting zapped the PMD. |
| In the Linux kernel, the following vulnerability has been resolved:
mm: fix address wraparound when scanning large folio PTEs
numa_rebuild_large_mapping() and do_swap_page() can be tricked into
generating an address wraparound, crashing the kernel. All that's required
is to map a tail page of a large folio close enough to the start/end of
the address space to e.g., make
unsigned long addr_start = addr - (nr << PAGE_SHIFT);
to wrap around.
Let's fix it by providing a better helper, folio_scan_range(), that
takes care of staying within VMA and page table boundaries while
handling possible wraparounds.
There are some nasty details, like not being able to use pmd_addr_end()
in this context. Add some helpful comments for these cases. |
| In the Linux kernel, the following vulnerability has been resolved:
mm/khugepaged: flush deferred unmaps before dropping a failed folio
collapse_file() can fail its reference-count or dirty-folio check after
unmapping with TTU_BATCH_FLUSH. Both paths put back the isolated folio,
then unlock it and drop the lookup reference before reaching the common
try_to_unmap_flush().
The page-cache reference does not keep the folio stable once the lock is
released. Another collapse can replace and free it. With its PTEs
already gone, that collapse cannot flush the first task's per-task TLB
batch, and retract_page_tables() skips short or unaligned VMAs. A CPU can
therefore retain a user translation to the freed folio. This has been
reproduced with unprivileged MADV_COLLAPSE on a memfd.
Flush at out_unlock while the lookup reference and folio lock are still
held. The common flush continues to cover the accumulated pagelist on
both success and rollback, preserving batching on successful collapses. |
| In the Linux kernel, the following vulnerability has been resolved:
KVM: x86: Conditionally resched when restarting REP string emulation
When restarting emulation, e.g. of a REP-prefixed string instruction,
conditionally reschedule as emulating guest writes can be deceptively slow
and expensive, e.g. when shadow paging is in use and each write can trigger
write tracking.
In a perfect world, restarting emulation (or not) would be less arbitrary,
e.g. would honor not only host events (NEED_RESCHED, signals, etc.) but
also guest events (e.g. by checking kvm_vcpu_has_events()). Unfortunately,
as pointed out by Sashiko, pio_in_emulated()'s read-ahead logic is baked
into the restart logic, as KVM relies on restarting emulation to drain the
cache and avoid duplicate reads from the I/O port. I.e. re-entering the
guest on kvm_vcpu_has_events() or __xfer_to_guest_mode_work_pending() would
introduce architecturally-incorrect, guest-visible changes. |
| In the Linux kernel, the following vulnerability has been resolved:
KVM: x86/mmu: Conditionally resched when retrying gPTE walk on A/D update failure
Conditionally reschedule when retrying a guest PTE walk because the CMPXCHG
to update A/D bits failed, e.g. because a different task/vCPU modified the
relevant gPTEs. On kernels without involuntary preemption of some kind, a
misbehaving guest can "capture" a pCPU effectively indefinitely and trigger
soft lockups by continuously modifying its gPTEs such that the result of
the walk is remains valid. |
| In JetBrains TeamCity before 2026.1.3, 2025.11.7 remote code execution was possible via best-fit character mapping in Perforce settings |
| In JetBrains TeamCity before 2026.1.3, 2025.11.7 remote code execution was possible via argument injection in Perforce settings |
| In JetBrains TeamCity before 2026.1.3, 2025.11.7 remote code execution was possible via build attribute injection |
| In JetBrains TeamCity before 2026.1.3, 2025.11.7 remote code execution was possible via argument injection in Mercurial VCS root settings |
| In JetBrains TeamCity before 2026.1.3, 2025.11.7 remote code execution was possible via path traversal in project import archives |
| In JetBrains TeamCity before 2026.1.3, 2025.11.7 remote code execution was possible via path traversal in the external artifact cache |
| In JetBrains TeamCity before 2026.1.3, 2025.11.8 disclosure of password parameter values to project viewers was possible |
| In JetBrains TeamCity before 2026.1.3, 2025.11.7 missing authorization in the Kubernetes integration allowed project viewers to use stored credentials |
| In JetBrains TeamCity before 2026.1.3, 2025.11.7 XXE via Maven settings file upload was possible |
| In JetBrains TeamCity before 2026.1.3, 2025.11.7 XXE in the .NET build steps auto-discovery was possible |
| In JetBrains TeamCity before 2026.1.3, 2025.11.7 stored XSS in the Promote build dialog was possible |