| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
ext4: fix memory leak in ext4_ext_shift_extents()
In ext4_ext_shift_extents(), if the extent is NULL in the while loop, the
function returns immediately without releasing the path obtained via
ext4_find_extent(), leading to a memory leak.
Fix this by jumping to the out label to ensure the path is properly
released. |
| In the Linux kernel, the following vulnerability has been resolved:
crypto: starfive - Fix memory leak in starfive_aes_aead_do_one_req()
The starfive_aes_aead_do_one_req() function allocates rctx->adata with
kzalloc() but fails to free it if sg_copy_to_buffer() or
starfive_aes_hw_init() fails, which lead to memory leaks.
Since rctx->adata is unconditionally freed after the write_adata
operations, ensure consistent cleanup by freeing the allocation in these
earlier error paths as well.
Compile tested only. Issue found using a prototype static analysis tool
and code review. |
| In the Linux kernel, the following vulnerability has been resolved:
md/raid5: fix IO hang with degraded array with llbitmap
When llbitmap bit state is still unwritten, any new write should force
rcw, as bitmap_ops->blocks_synced() is checked in handle_stripe_dirtying().
However, later the same check is missing in need_this_block(), causing
stripe to deadloop during handling because handle_stripe() will decide
to go to handle_stripe_fill(), meanwhile need_this_block() always return
0 and nothing is handled. |
| In the Linux kernel, the following vulnerability has been resolved:
fbdev: au1200fb: Fix a memory leak in au1200fb_drv_probe()
In au1200fb_drv_probe(), when platform_get_irq fails(), it directly
returns from the function with an error code, which causes a memory
leak.
Replace it with a goto label to ensure proper cleanup. |
| In the Linux kernel, the following vulnerability has been resolved:
ublk: Validate SQE128 flag before accessing the cmd
ublk_ctrl_cmd_dump() accesses (header *)sqe->cmd before
IO_URING_F_SQE128 flag check. This could cause out of boundary memory
access.
Move the SQE128 flag check earlier in ublk_ctrl_uring_cmd() to return
-EINVAL immediately if the flag is not set. |
| In the Linux kernel, the following vulnerability has been resolved:
SUNRPC: fix gss_auth kref leak in gss_alloc_msg error path
Commit 5940d1cf9f42 ("SUNRPC: Rebalance a kref in auth_gss.c") added
a kref_get(&gss_auth->kref) call to balance the gss_put_auth() done
in gss_release_msg(), but forgot to add a corresponding kref_put()
on the error path when kstrdup_const() fails.
If service_name is non-NULL and kstrdup_const() fails, the function
jumps to err_put_pipe_version which calls put_pipe_version() and
kfree(gss_msg), but never releases the gss_auth reference. This leads
to a kref leak where the gss_auth structure is never freed.
Add a forward declaration for gss_free_callback() and call kref_put()
in the err_put_pipe_version error path to properly release the
reference taken earlier. |
| In the Linux kernel, the following vulnerability has been resolved:
eth: fbnic: Add validation for MTU changes
Increasing the MTU beyond the HDS threshold causes the hardware to
fragment packets across multiple buffers. If a single-buffer XDP program
is attached, the driver will drop all multi-frag frames. While we can't
prevent a remote sender from sending non-TCP packets larger than the MTU,
this will prevent users from inadvertently breaking new TCP streams.
Traditionally, drivers supported XDP with MTU less than 4Kb
(packet per page). Fbnic currently prevents attaching XDP when MTU is too high.
But it does not prevent increasing MTU after XDP is attached. |
| In the Linux kernel, the following vulnerability has been resolved:
x86/shstk: Prevent deadlock during shstk sigreturn
During sigreturn the shadow stack signal frame is popped. The kernel does
this by reading the shadow stack using normal read accesses. When it can't
assume the memory is shadow stack, it takes extra steps to makes sure it is
reading actual shadow stack memory and not other normal readable memory. It
does this by holding the mmap read lock while doing the access and checking
the flags of the VMA.
Unfortunately that is not safe. If the read of the shadow stack sigframe
hits a page fault, the fault handler will try to recursively grab another
mmap read lock. This normally works ok, but if a writer on another CPU is
also waiting, the second read lock could fail and cause a deadlock.
Fix this by not holding mmap lock during the read access to userspace.
Instead use mmap_lock_speculate_...() to watch for changes between dropping
mmap lock and the userspace access. Retry if anything grabbed an mmap write
lock in between and could have changed the VMA.
These mmap_lock_speculate_...() helpers use mm::mm_lock_seq, which is only
available when PER_VMA_LOCK is configured. So make X86_USER_SHADOW_STACK
depend on it. On x86, PER_VMA_LOCK is a default configuration for SMP
kernels. So drop support for the other configs under the assumption that
the !SMP shadow stack user base does not exist.
Currently there is a check that skips the lookup work when the SSP can be
assumed to be on a shadow stack. While reorganizing the function, remove
the optimization to make the tricky code flows more common, such that
issues like this cannot escape detection for so long. |
| In the Linux kernel, the following vulnerability has been resolved:
jbd2: fix deadlock in jbd2_journal_cancel_revoke()
Commit f76d4c28a46a ("fs/jbd2: use sleeping version of
__find_get_block()") changed jbd2_journal_cancel_revoke() to use
__find_get_block_nonatomic() which holds the folio lock instead of
i_private_lock. This breaks the lock ordering (folio -> buffer) and
causes an ABBA deadlock when the filesystem blocksize < pagesize:
T1 T2
ext4_mkdir()
ext4_init_new_dir()
ext4_append()
ext4_getblk()
lock_buffer() <- A
sync_blockdev()
blkdev_writepages()
writeback_iter()
writeback_get_folio()
folio_lock() <- B
ext4_journal_get_create_access()
jbd2_journal_cancel_revoke()
__find_get_block_nonatomic()
folio_lock() <- B
block_write_full_folio()
lock_buffer() <- A
This can occasionally cause generic/013 to hang.
Fix by only calling __find_get_block_nonatomic() when the passed
buffer_head doesn't belong to the bdev, which is the only case that we
need to look up its bdev alias. Otherwise, the lookup is redundant since
the found buffer_head is equal to the one we passed in. |
| In the Linux kernel, the following vulnerability has been resolved:
crypto: qat - fix IRQ cleanup on 6xxx probe failure
When adf_dev_up() partially completes and then fails, the IRQ
handlers registered during adf_isr_resource_alloc() are not detached
before the MSI-X vectors are released.
Since the device is enabled with pcim_enable_device(), calling
pci_alloc_irq_vectors() internally registers pcim_msi_release() as a
devres action. On probe failure, devres runs pcim_msi_release() which
calls pci_free_irq_vectors(), tearing down the MSI-X vectors while IRQ
handlers (for example 'qat0-bundle0') are still attached. This causes
remove_proc_entry() warnings:
[ 22.163964] remove_proc_entry: removing non-empty directory 'irq/143', leaking at least 'qat0-bundle0'
Moving the devm_add_action_or_reset() before adf_dev_up() does not solve
the problem since devres runs in LIFO order and pcim_msi_release(),
registered later inside adf_dev_up(), would still fire before
adf_device_down().
Fix by calling adf_dev_down() explicitly when adf_dev_up() fails, to
properly free IRQ handlers before devres releases the MSI-X vectors. |
| In the Linux kernel, the following vulnerability has been resolved:
ocfs2: cancel dqi_sync_work before freeing oinfo
ocfs2_global_read_info() will initialize and schedule dqi_sync_work at the
end, if error occurs after successfully reading global quota, it will
trigger the following warning with CONFIG_DEBUG_OBJECTS_* enabled:
ODEBUG: free active (active state 0) object: 00000000d8b0ce28 object type: timer_list hint: qsync_work_fn+0x0/0x16c
This reports that there is an active delayed work when freeing oinfo in
error handling, so cancel dqi_sync_work first. BTW, return status instead
of -1 when .read_file_info fails. |
| In the Linux kernel, the following vulnerability has been resolved:
platform/x86: x86-android-tablets: Fix use after free on platform_device_register() errors
x86_android_tablet_remove() frees the pdevs[] array, so it should not
be used after calling x86_android_tablet_remove().
When platform_device_register() fails, store the pdevs[x] PTR_ERR() value
into the local ret variable before calling x86_android_tablet_remove()
to avoid using pdevs[] after it has been freed. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: fix double free issue during amdgpu module unload
Flexible endpoints use DIGs from available inflexible endpoints,
so only the encoders of inflexible links need to be freed.
Otherwise, a double free issue may occur when unloading the
amdgpu module.
[ 279.190523] RIP: 0010:__slab_free+0x152/0x2f0
[ 279.190577] Call Trace:
[ 279.190580] <TASK>
[ 279.190582] ? show_regs+0x69/0x80
[ 279.190590] ? die+0x3b/0x90
[ 279.190595] ? do_trap+0xc8/0xe0
[ 279.190601] ? do_error_trap+0x73/0xa0
[ 279.190605] ? __slab_free+0x152/0x2f0
[ 279.190609] ? exc_invalid_op+0x56/0x70
[ 279.190616] ? __slab_free+0x152/0x2f0
[ 279.190642] ? asm_exc_invalid_op+0x1f/0x30
[ 279.190648] ? dcn10_link_encoder_destroy+0x19/0x30 [amdgpu]
[ 279.191096] ? __slab_free+0x152/0x2f0
[ 279.191102] ? dcn10_link_encoder_destroy+0x19/0x30 [amdgpu]
[ 279.191469] kfree+0x260/0x2b0
[ 279.191474] dcn10_link_encoder_destroy+0x19/0x30 [amdgpu]
[ 279.191821] link_destroy+0xd7/0x130 [amdgpu]
[ 279.192248] dc_destruct+0x90/0x270 [amdgpu]
[ 279.192666] dc_destroy+0x19/0x40 [amdgpu]
[ 279.193020] amdgpu_dm_fini+0x16e/0x200 [amdgpu]
[ 279.193432] dm_hw_fini+0x26/0x40 [amdgpu]
[ 279.193795] amdgpu_device_fini_hw+0x24c/0x400 [amdgpu]
[ 279.194108] amdgpu_driver_unload_kms+0x4f/0x70 [amdgpu]
[ 279.194436] amdgpu_pci_remove+0x40/0x80 [amdgpu]
[ 279.194632] pci_device_remove+0x3a/0xa0
[ 279.194638] device_remove+0x40/0x70
[ 279.194642] device_release_driver_internal+0x1ad/0x210
[ 279.194647] driver_detach+0x4e/0xa0
[ 279.194650] bus_remove_driver+0x6f/0xf0
[ 279.194653] driver_unregister+0x33/0x60
[ 279.194657] pci_unregister_driver+0x44/0x90
[ 279.194662] amdgpu_exit+0x19/0x1f0 [amdgpu]
[ 279.194939] __do_sys_delete_module.isra.0+0x198/0x2f0
[ 279.194946] __x64_sys_delete_module+0x16/0x20
[ 279.194950] do_syscall_64+0x58/0x120
[ 279.194954] entry_SYSCALL_64_after_hwframe+0x6e/0x76
[ 279.194980] </TASK> |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amdkfd: amdkfd_free_gtt_mem clear the correct pointer
Pass pointer reference to amdgpu_bo_unref to clear the correct pointer,
otherwise amdgpu_bo_unref clear the local variable, the original pointer
not set to NULL, this could cause use-after-free bug. |
| In the Linux kernel, the following vulnerability has been resolved:
ALSA: asihpi: Fix potential OOB array access
ASIHPI driver stores some values in the static array upon a response
from the driver, and its index depends on the firmware. We shouldn't
trust it blindly.
This patch adds a sanity check of the array index to fit in the array
size. |
| CAI Content Credentials versions c2pa-web@0.7.1, c2pa-v0.80.1 and earlier are affected by an Improper Limitation of a Pathname to a Restricted Directory ('Path Traversal') vulnerability that could result in an arbitrary file system write. An attacker could leverage this vulnerability to write to unauthorized files or directories outside of intended restrictions. Exploitation of this issue requires user interaction in that a victim must extract a maliciously crafted file. |
| CAI Content Credentials versions c2pa-web@0.7.1, c2pa-v0.80.1 and earlier are affected by an Integer Overflow or Wraparound vulnerability. An attacker could exploit this vulnerability to crash the application, leading to a denial-of-service condition. Exploitation of this issue does not require user interaction. |
| This CVE ID has been rejected or withdrawn by its CVE Numbering Authority. |
| This CVE ID has been rejected or withdrawn by its CVE Numbering Authority. |
| This CVE ID has been rejected or withdrawn by its CVE Numbering Authority. |
