| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| Omission of security-relevant information for some Intel(R) Software Guard Extensions Data Center Attestation Primitives within Ring 0: Kernel may allow a denial of service. Authorized adversary with a privileged user combined with a high complexity attack may enable data alteration. This result may potentially occur via local access when attack requirements are present with special internal knowledge and requires no user interaction. The potential vulnerability may impact the confidentiality (none), integrity (low) and availability (low) of the vulnerable system, resulting in subsequent system confidentiality (none), integrity (high) and availability (low) impacts. |
| Initialization of a Resource with an Insecure Default vulnerability in Hallo Welt! GmbH BlueSpice (container image bluespice/wiki) allows privilege escalation. The default value of $mwsgTokenAuthenticatorServiceCIDR in the container's LocalSettings.php was intended to restrict internal service authentication to the container network, but evaluated to an empty string when the environment variable WIKI_SERVICE_TOKEN_AUTH_ALLOWED was not set. An empty value disables the IP restriction in the token authenticator component (mwstake/mediawiki-component-token-authenticator). As a result, any user with read access to the wiki (anonymous users on publicly readable wikis) could obtain an application token from the REST API and use it to get a session with sysop privileges as the internal service user.
This issue affects BlueSpice: from 5.2.3 before 5.2.7, and the 5.2.7 container images published before 2026-10-19 15:37 UTC. |
| Zephyr's OpenThread integration defined CONFIG_OPENTHREAD_JOINER_PSKD with default "J01NME" in modules/openthread/Kconfig.thread (previously subsys/net/l2/openthread/Kconfig, then subsys/net/l2/openthread/Kconfig.thread). J01NME is the example Joining Device Credential used throughout the public OpenThread and Thread commissioning documentation, including Zephyr's own samples/net/sockets/echo_client/README.rst, so it is not a secret. A firmware image built with CONFIG_OPENTHREAD_JOINER_AUTOSTART=y that never overrode the PSKd therefore shipped with a publicly known joining credential compiled in, with no build-time or run-time warning.
The PSKd is the only value that authenticates Thread commissioning: joiner and commissioner run a DTLS-PSK handshake keyed on it, after which the commissioner supplies the full operational dataset. In ot_configure_instance() (modules/openthread/openthread.c), a device with no stored dataset calls otJoinerStart() with the configured PSKd, and ot_joiner_start_handler() calls otThreadSetEnabled() on success. An unauthenticated attacker within 802.15.4 radio range of an uncommissioned device (factory-fresh, after a factory reset, or after a settings erase) can run any stock Thread commissioner registered with J01NME, complete the handshake, and hand the device an attacker-controlled operational dataset.
The device then joins and enables Thread on the attacker's mesh. The attacker becomes its router, seeing, dropping, injecting and spoofing all of the device's IPv6 traffic and impersonating the peers the application expects, while the device is cut off from the network it was meant to join and stays mis-provisioned until it is reset. Only application-layer security with independently provisioned credentials survives. Exposure is limited to builds that enable joiner autostart and leave the PSKd unset; the option is not enabled by default and no in-tree sample uses the vulnerable combination.
The fix removes the default from CONFIG_OPENTHREAD_JOINER_PSKD and adds a BUILD_ASSERT() in modules/openthread/openthread.c, active only under CONFIG_OPENTHREAD_JOINER_AUTOSTART, that fails the build unless a 6-to-32-character PSKd is configured. Products should provision a per-device PSKd from factory data and call otJoinerStart() from the application rather than relying on a credential compiled identically into every unit. |
| Broken access control in JiraController in Cervantes version v1.3-beta could allow an attacker to create, edit, or delete Jira tickets for vulnerabilities in other projects |
| An incomplete list of disallowed inputs in the Python code validator of the run_script tool in AWS MCP Server might allow an authenticated remote user to execute arbitrary code within their own isolated session environment via a crafted script.
AWS fixed this issue service-side. No customer action is required. |
| Server-side request forgery in the model download path in Amazon Web Services Multi Model Server 1.1.11 and earlier might allow remote actors to send requests to internal network destinations via a crafted model URL.
Multi Model Server is end of life and no fixed version is available. Users should discontinue use of Multi Model Server and migrate to a supported model serving solution. |
| Relative path traversal during model archive extraction in Amazon Web Services Multi Model Server 1.1.11 and earlier might allow remote actors to execute arbitrary code via a crafted model archive.
Multi Model Server is end of life and no fixed version is available. Users should discontinue use of Multi Model Server and migrate to a supported model serving solution. |
| A flaw in Node.js TLS hostname verification can cause a server certificate to be validated against a different IP address than the one the client connected to, when the host is a non-canonical IPv4 literal with a leading zero, such as `0127.0.0.1`.
`tls.checkServerIdentity()` normalizes the host following the WHATWG URL rules, which read a leading-zero octet as octal (`0127.0.0.1` becomes `87.0.0.1`), while the connection is made through the operating system resolver, which on some platforms such as macOS reads it as decimal (`127.0.0.1`). A server at the connected address can then be authenticated with a certificate issued for another IP address.
This vulnerability affects Node.js **26.x**, **24.x**, and **22.x**. |
| In the Linux kernel, the following vulnerability has been resolved:
autofs: ignore notification errors from a replaced pipe
autofs_notify_daemon() takes a reference to the current notification
pipe under wq_mutex, then drops the mutex before writing the request. The
write can block while the daemon enters catatonic mode and installs a
replacement pipe.
If the old pipe's reader is then closed, the delayed write returns -EPIPE
and the generic error path enters catatonic mode again. That transition
acts on the current superblock state, closes the replacement pipe, and
releases the new daemon generation's wait queues.
Only enter catatonic mode when the pipe which failed is still the current
pipe. Factor the already-locked transition so the identity check and state
change are atomic with respect to another replacement.
This was reproduced on v7.3-rc5-337-gff47652a4b66c in a local QEMU guest.
An unprivileged UID 65534 lookup filled the old packet pipe before a
normal CATATONIC/SETPIPEFD restart. On the unmodified kernel, the new pipe
received HUP and both a pending victim lookup and a later lookup failed
with ENOENT in two out of two fresh-mount runs.
With this change, the new pipe remained active, received an intact
304-byte request, and both victim lookups completed in two out of two
runs. Normal lookup and restart-without-a-blocked-writer controls passed.
No KASAN, oops, refcount, or lock diagnostic was observed. A source
reproducer and complete local logs are available privately on request.
The demonstrated impact is limited to denial of a shared autofs service
during a legitimate daemon restart. No memory corruption, information leak,
privilege escalation, or code execution primitive was observed. |
| In the Linux kernel, the following vulnerability has been resolved:
net: bcmgenet: unshare the skb before writing the control block
bcmgenet stores first_cb, last_cb and bytes_sent in the skb control
block and reads them back on completion to free the skb and credit BQL.
ether_setup() leaves IFF_TX_SKB_SHARING set, so the stack can resubmit
a shared skb that is still in the ring. The next transmit overwrites
last_cb, so the earlier slots complete without crediting their bytes
and BQL stalls the queue until the watchdog resets it.
Unshare the skb before writing the control block.
Reproduce with pktgen in clone_skb mode, which hands the driver the same
skb while earlier copies are still in the ring:
modprobe pktgen
pg=/proc/net/pktgen
echo "add_device eth0" > $pg/kpktgend_0
echo "dst_mac AA:BB:CC:DD:EE:FF" > $pg/eth0
echo "dst 192.0.2.1" > $pg/eth0
echo "clone_skb 8" > $pg/eth0
echo "count 0" > $pg/eth0
echo start > $pg/pgctrl &
sleep 5
echo stop > $pg/pgctrl
wait
cat /sys/class/net/eth0/queues/tx-0/byte_queue_limits/inflight
inflight stays nonzero on the now idle queue. clone_skb 0 leaves it at
zero. |
| In the Linux kernel, the following vulnerability has been resolved:
scsi: libsas: Fix SMP IO deadlock during HA resume
smp_execute_task_sg() calls pm_runtime_get_sync() on the host before
issuing an SMP command. When that command is itself issued from the HA
resume path, the get_sync() deadlocks: it waits for the ongoing resume
(the device is RPM_RESUMING), while the resume is blocked in
sas_drain_work() waiting for that same SMP IO to complete.
The deadlock needs an expander-attached SATA disk. During
sas_resume_ha() -> sas_drain_work(), DISCE_RESUME -> sas_resume_sata()
-> ata_sas_port_resume() requests ATA_EH_RESET, and the hard reset for
such a disk is done via SMP PHY CONTROL (sas_ata_hard_reset() ->
sas_phy_reset() -> sas_smp_phy_control() ->
smp_execute_task_sg()). Direct-attached SATA resets through
lldd_control_phy() and SSP devices use TMFs, so neither hits this.
Replace the get_sync()/put_sync() pair with
pm_runtime_get_noresume()/pm_runtime_put(). smp_execute_task_sg() only
needs to hold off autosuspend while the SMP is in flight, and it must
not try to resume the host: a sync resume issued from the HA resume path
itself is what deadlocks, and by the time sas_resume_ha() runs, hw_init
has already reinitialized the hardware, so the device is accessible
without one.
The usage reference is still required. Discovery work normally runs
inside an event worker's PM reference, taken at sas_notify_port_event()
notify time and held until the handler has flushed the disco
queue. sas_rediscover_ex_phy() however requeues DISCE_REVALIDATE_DOMAIN
from within the revalidation worker itself, and flush_workqueue() does
not wait for work items queued during execution, so that chained
revalidation runs with no outer PM reference - without the
get_noresume(), its SMP could race autosuspend.
For the BSG path, sas_smp_handler() is the only caller which may find
the host autosuspended: expander SMP requests do not go through any SCSI
device request queue, so nothing else in that path holds the host
awake. Resume it there with pm_runtime_resume_and_get() and check the
result. |
| Dell OpenManage Enterprise, versions prior to 4.8.0, contains an Improper Limitation of a Pathname to a Restricted Directory ('Path Traversal') vulnerability. A high privileged attacker with adjacent network access could potentially exploit this vulnerability, leading to Filesystem access for attacker. |
| Dell OpenManage Enterprise, versions prior to 4.8.0, contains an Improper Neutralization of Special Elements used in an OS Command ('OS Command Injection') vulnerability. A low privileged attacker with adjacent network access could potentially exploit this vulnerability, leading to Command execution. |
| Dell OpenManage Enterprise, versions prior to 4.8.0, contains an Improper Verification of Cryptographic Signature vulnerability. A high privileged attacker with adjacent network access could potentially exploit this vulnerability, leading to Code execution. |
| IDOR in Cervantes version v1.3-beta could allow an authenticated attacker ca access sensitive findings, proof-of-concept details, credentials, and client information from projects they do not belong to. Additionally, they can modify finding statuses and transfer findings to their own projects, compromising data confidentiality and integrity. |
| BOLA Allows Cross-Project Target Tampering
in Cervantes version v1.3-beta could allow an attacker modify or delete targets belonging to other projects without authorization, compromising the integrity of penetration testing scopes, results, and associated security reports. |
| Stored XSS vulnerability in the “Notes” field of the Checklists in Cervantes version v1.3-beta could allow an attacker to execute arbitrary code in another user's browser with elevated privileges |
| Dell OpenManage Enterprise, versions prior to 4.8.0, contains an Improper Limitation of a Pathname to a Restricted Directory ('Path Traversal') vulnerability. A low privileged attacker with adjacent network access could potentially exploit this vulnerability, leading to Information exposure. |
| Dell OpenManage Enterprise, versions prior to 4.8.0, contains an Improper Neutralization of Argument Delimiters in a Command ('Argument Injection') vulnerability. A low privileged attacker with adjacent network access could potentially exploit this vulnerability, leading to Command execution. |
| Dell OpenManage Enterprise, versions prior to 4.8.0, contains an Improper Neutralization of Input During Web Page Generation ('Cross-site Scripting') vulnerability. An unauthenticated attacker with remote access could potentially exploit this vulnerability, leading to Information tampering |
