| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A denial-of-service vulnerability exists in the affected products. The vulnerability could allow a remote, non-privileged user to send malicious requests resulting in a major nonrecoverable fault causing a denial-of-service. |
| In EMQX before 5.8.6, administrators can install arbitrary novel plugins via the Dashboard web interface. NOTE: the Supplier's position is that this is the intended behavior; however, 5.8.6 adds a defense-in-depth feature in which a plugin's acceptability (for later Dashboard installation) is set by the "emqx ctl plugins allow" CLI command. |
| Improper conditions check in some firmware for some Intel(R) NPU Drivers within Ring 1: Device Drivers may allow a denial of service. Unprivileged software adversary with an authenticated user combined with a high complexity attack may enable denial of service. This result may potentially occur via local access when attack requirements are not present without special internal knowledge and requires no user interaction. The potential vulnerability may impact the confidentiality (none), integrity (none) and availability (high) of the vulnerable system, resulting in subsequent system confidentiality (none), integrity (none) and availability (none) impacts. |
| A potential security vulnerability has been identified in the HPE NonStop DISK UTIL (T9208) product. This vulnerability could be exploited to cause a denial of service (DoS) to NonStop server. It exists in all prior DISK UTIL product versions of L-series and J-series. |
| React Router is a router for React. Starting in version 7.2.0 and prior to version 7.5.2, it is possible to force an application to switch to SPA mode by adding a header to the request. If the application uses SSR and is forced to switch to SPA, this causes an error that completely corrupts the page. If a cache system is in place, this allows the response containing the error to be cached, resulting in a cache poisoning that strongly impacts the availability of the application. This issue has been patched in version 7.5.2. |
| A denial-of-service (DoS) vulnerability in Palo Alto Networks PAN-OS software enables an unauthenticated attacker to reboot a firewall by sending a specially crafted packet through the dataplane. Repeated attempts to initiate a reboot causes the firewall to enter maintenance mode.
This issue is applicable to the PAN-OS software versions listed below on PA-Series firewalls, VM-Series firewalls, and Prisma® Access software. This issue does not affect Cloud NGFW.
We have successfully completed the Prisma Access upgrade for all customers, with the exception of those facing issues such as conflicting maintenance windows. Remaining customers will be promptly scheduled for an upgrade through our standard upgrade process. |
| Polkadot Frontier is an Ethereum and EVM compatibility layer for Polkadot and Substrate. The extrinsic note_min_gas_price_target is an inherent extrinsic, meaning only the block producer can call it. To ensure correctness, the ProvideInherent trait should be implemented for each inherent, which includes the check_inherent call. This allows other nodes to verify if the input (in this case, the target value) is correct. However, prior to commit a754b3d, the check_inherent function has not been implemented for note_min_gas_price_target. This lets the block producer set the target value without verification. The target is then used to set the MinGasPrice, which has an upper and lower bound defined in the on_initialize hook. The block producer can set the target to the upper bound. Which also increases the upper and lower bounds for the next block. Over time, this could result in continuously raising the gas price, making contract execution too expensive and ineffective for users. An attacker could use this flaw to manipulate the gas price, potentially leading to significantly inflated transaction fees. Such manipulation could render contract execution prohibitively expensive for users, effectively resulting in a denial-of-service condition for the network. This is fixed in version a754b3d. |
| The sequence of packets received by a Networking server are not correctly checked.
An attacker could exploit this vulnerability to send specially crafted messages to force the application to stop. |
| Improper conditions check for some Intel(R) Arc™ GPU may allow an authenticated user to potentially enable denial of service via local access. |
| An unauthenticated remote attacker can causes the CODESYS web server to access invalid memory which results in a DoS. |
| Improper conditions check in Linux kernel mode driver for some Intel(R) Ethernet Network Controllers and Adapters E810 Series before version 28.3 may allow an authenticated user to potentially enable denial of service via local access. |
| JGraphT Core v1.5.2 was discovered to contain a NullPointerException via the component org.jgrapht.alg.util.ToleranceDoubleComparator::compare(Double, Double). NOTE: this is disputed by multiple third parties who believe there was not reasonable evidence to determine the existence of a vulnerability. The submission may have been based on a tool that is not sufficiently robust for vulnerability identification. |
| An application can be configured to block boot attempts after consecutive tamper resets are detected, which may not occur as expected.
This is possible because the TAMPERRSTCAUSE register may not be properly updated when a level 4 tamper event (a tamper reset) occurs. This impacts Series 2 HSE-SVH devices, including xG23B, xG24B, xG25B, and xG28B, but does not impact xG21B. To mitigate this issue, upgrade to SE Firmware version 2.2.6 or later. |
| Kata Containers is an open source project focusing on a standard implementation of lightweight Virtual Machines (VMs) that perform like containers. In Kata Containers versions from 3.20.0 and before, a malicious host can circumvent initdata verification. On TDX systems running confidential guests, a malicious host can selectively fail IO operations to skip initdata verification. This allows an attacker to launch arbitrary workloads while being able to attest successfully to Trustee impersonating any benign workload. This issue has been patched in Kata Containers version 3.21.0. |
| Improper check for unusual or exceptional conditions in Intel(R) TDX Module firmware before version 1.5.06 may allow a privileged user to potentially enable information disclosure via local access. |
| A denial-of-service (DoS) vulnerability in the Simple Certificate Enrollment Protocol (SCEP) authentication feature of Palo Alto Networks PAN-OS® software enables an unauthenticated attacker to initiate system reboots using a maliciously crafted packet. Repeated attempts to initiate a reboot causes the firewall to enter maintenance mode.
Cloud NGFW is not affected by this vulnerability. Prisma® Access software is proactively patched and protected from this issue. |
| In OpenStack Neutron before 25.0.1, neutron/extensions/tagging.py can use an incorrect ID during policy enforcement. It does not apply the proper policy check for changing network tags. An unprivileged tenant is able to change (add and clear) tags on network objects that do not belong to the tenant, and this action is not subjected to the proper policy authorization check. This affects 23 before 23.2.1, 24 before 24.0.2, and 25 before 25.0.1. |
| When SmartStart Inclusion fails during the onboarding of a Z-Wave PIR sensor, the sensor will join the network as a non-secure device. This vulnerability exists in Silicon Labs' Z-Wave PIR Sensor Reference design delivered as part of SiSDK v2025.6.0 and v2025.6.1. |
| A vulnerability has been identified in SIPROTEC 4 6MD61 (All versions), SIPROTEC 4 6MD63 (All versions), SIPROTEC 4 6MD66 (All versions), SIPROTEC 4 6MD665 (All versions), SIPROTEC 4 7SA522 (All versions), SIPROTEC 4 7SA6 (All versions < V4.78), SIPROTEC 4 7SD5 (All versions < V4.78), SIPROTEC 4 7SD610 (All versions < V4.78), SIPROTEC 4 7SJ61 (All versions), SIPROTEC 4 7SJ62 (All versions), SIPROTEC 4 7SJ63 (All versions), SIPROTEC 4 7SJ64 (All versions), SIPROTEC 4 7SJ66 (All versions), SIPROTEC 4 7SS52 (All versions), SIPROTEC 4 7ST6 (All versions), SIPROTEC 4 7UM61 (All versions), SIPROTEC 4 7UM62 (All versions), SIPROTEC 4 7UT612 (All versions), SIPROTEC 4 7UT613 (All versions), SIPROTEC 4 7UT63 (All versions), SIPROTEC 4 7VE6 (All versions), SIPROTEC 4 7VK61 (All versions), SIPROTEC 4 7VU683 (All versions), SIPROTEC 4 Compact 7RW80 (All versions), SIPROTEC 4 Compact 7SD80 (All versions), SIPROTEC 4 Compact 7SJ80 (All versions), SIPROTEC 4 Compact 7SJ81 (All versions), SIPROTEC 4 Compact 7SK80 (All versions), SIPROTEC 4 Compact 7SK81 (All versions). Affected devices do not properly handle interrupted operations of file transfer. This could allow an unauthenticated remote attacker to cause a denial of service condition. To restore normal operations, the devices need to be restarted. |
| Team ENVY, a Security Research TEAM has found a flaw that allows for a remote code execution on the NVR. An attacker could inject malformed data into url input parameters to reboot the NVR. The manufacturer has released patch firmware for the flaw, please refer to the manufacturer's report for details and workarounds. |
